See your brand name in lights! Just turn
on, and a single row of super bright LED
lights blink randomly until the flying disc
is launched. As it soars above the crowd,
the spinning lights magically write your
message. The letters are visible at any
angle from dusk til dawn. Take your next
promotion into a whole new dimension.

        Program your message into the on-board
        computer and your E*Writer is ready to go.
        When activated, the single row of super bright
        LED lights blink randomly until the E*Writer
        is luanched. With a flick of your wrist, it spins
        thru the night sky, magically writing your
        name, message or anything you want!


            

To Program Your Name or Message

1. Switch ON

2. Press SET button and hold (approx. 10 seconds) until the LEDs turn off.

3. Select letters or numbers by pressing UP or DOWN buttons the appropriate number of times (see easy programming chart below), then press the SET button after each one.

4. For spaces between characters, press the SET button.

5. To store, switch OFF, switch ON and your message is stored.

If no message is stored, a default message will be displayed.

To Re-Program a New Name or Message
1. Switch OFF. Then simply repeat steps above.

The maximum number of characters including spaces can be 12.

To switch messages to read from Right handed thrower to Left handed thrower, turn disc OFF. Switch ON again and press DOWN button for 5 seconds. The LEDs will blink briefly to confirm your request. To switch back simply repeat.

*TIP: If you go past the desired letter or number, simply press the other "UP" or "DOWN" button the appropriate number of times to scroll back to the desired letter or number.

NOTE: Do not use near water.